This section describes using the web-based PMDF-LAN configuration
utility. A command line variant,
pmdf configure lan, is
also available for sites for whom web configuration is not convenient.
The web-based configuration utility can be used to generate an initial
PMDF-LAN configuration, or it can be used to generate a new
configuration of an existing PMDF-LAN installation.
localhostis the TCP/IP name of your PMDF system---you should see a page such as shown in Figure 5-3---and then select the Configuration Utilities link; at this point you should see a page such as shown in Figure 5-4.
If your last use of the web-based PMDF configuration utility was to configure PMDF-MTA and your PMDF-MTA configuration has not been manually modified since then, you can load your prior PMDF-MTA configuration session before beginning your PMDF-LAN configuration; or if you want to redo your PMDF-MTA configuration, you can start by doing so now; either will minimize the number of checklist tasks you will later need to perform. Otherwise, you can configure just PMDF-LAN during this configuration sessions (and then perform checklist tasks to integrate your PMDF-LAN configuration into your main PMDF-MTA configuration).
Click on the Configure button for PMDF-LAN to begin the configuration.