PMDF Obsolete Features
2.3 Setting Up a Local Jnet Channel
The first step in configuring Jnet to work with PMDF is to install PMDF
Jnet on the same system. Once this is done a local
Jnet channel should be set up. This is described below.
PMDF CONFIGURE utility can be used to configure your
system with the appropriate
BITNET channels automatically.
When the PMDF configuration utility is used, all of the necessary
configuration steps except for those described in Section 2.11.1 are done
for you automatically. Consult the OpenVMS edition of the PMDF Installation Guide
for instructions on using the
Process Software strongly recommends that you use the supplied
PMDF CONFIGURE utility.