The following is a list of tasks which must be completed following an upgrade installation of PMDF.

1. If you are using a compiled configuration, you must recompile it after an upgrade of PMDF with the command:

   pmdf cnbuild

2. The format of the SleepyCat environment files has not changed between PMDF V6.2-1 and V6.3, but if you are upgrading from a version prior to V6.2-1, you must do the following. These database environment files must be deleted via the commands:

   del c:\pmdf\table\__db.* del c:\pmdf\tmp\__db.*

3. Start up the PMDF Job Controller and PMDF Service Dispatcher using the command:

   pmdf startup

4. If you also installed PMDF-DIRSYNC, PMDF-LAN, or PMDF-XGS for the first time, then you should configure them now. Configuration instructions for PMDF-LAN may be found in Chapter 6 and Chapter 7.